Mitutoyo | Caliper Error Code E05 Link //top\\

To resolve the E05 error code on your Mitutoyo caliper, follow these step-by-step troubleshooting procedures:

The encoder disks are held in place by spring pressure and set screws. If these loosen, the sensor cannot read the disk properly.

In Mitutoyo’s Digimatic ecosystem, errors starting with "E" signal an electronic calculation or sensor issue. mitutoyo caliper error code e05 link

E05 is not a standard Mitutoyo error for calipers. Most cases trace to battery failure, contaminated scale, or counterfeit units. Following the above diagnostic steps will resolve or correctly identify the issue. If a genuine Mitutoyo caliper displays E05, it should be returned for factory service.

Carefully remove the screws holding the encoder unit together (usually 2–3 screws). To resolve the E05 error code on your

: If the device is dropped or bumped, the internal encoder disc or sensor board can physically shift away from the reading array.

The data cable is not securely seated in the caliper output port or the receiving USB/Digimatic port. E05 is not a standard Mitutoyo error for calipers

Genuine Mitutoyo calipers (500-196-30, etc.) never display E05. Contact Mitutoyo support with serial number if code persists.