Kes Geyser Load Control Timer Manual New !!top!! 🆒 🔥

After installation, mark your panel with the current time and date of last reset so you can quickly realign the timer after an outage.

Toggles the output mode between ON , AUTO , and OFF . How to Program Your KES Geyser Timer 1. Setting the Current Time and Day

The inside your distribution board The specific issue you are encountering during programming kes geyser load control timer manual new

Assumption: model supports weekly programming with multiple events.

Connect the Live (Red) wire from the 20A geyser circuit breaker to the L1 terminal. After installation, mark your panel with the current

Check if the "Auto" indicator is visible. Also, ensure your "ON" and "OFF" times don't overlap.

If you need water urgently, use the manual override outside of peak hours. For long-term savings, ensure your geyser thermostat is set between 55°C and 60°C . Setting the Current Time and Day The inside

: To change the active program, typically you must hold or press specific buttons (like "program" or "override") until the Blue LED flashes the desired number of times.