A: 500 users (500 RFID cards or 500 PIN codes, or a mix).
: Incorrect relay wiring or insufficient power to the lock.
Drill holes for the screws and cable entry on the wall or door frame.
The following technical specifications were compiled from multiple product listings and manuals. Please verify your device's exact specifications. V2000-c Rfid Access Control User Manual
Installing and configuring the V2000-C RFID access control system requires careful planning and attention to detail. Here are the general steps involved in installing and configuring the system:
A: The system password can be reset to the factory default 12345 by performing the System Initialisation procedure. This will not delete your user cards.
Press * twice ( ** ) to return the unit to standard operation. Modifying the Master Admin Code A: 500 users (500 RFID cards or 500 PIN codes, or a mix)
Connect the wire of the V2000-C directly to the Positive (+) terminal of the Electric Strike. 3. Programming and Configuration Guide
The V2000-c uses a star-prefix command structure. [Master Code] + [#] .
I can provide a custom wiring diagram step or exact programming sequences for your specific setup. Share public link Here are the general steps involved in installing
If you cannot enter programming mode, you must reset the device to factory defaults. Power off the unit, press and hold the exit button, power on, and wait for the beeps.
The system will revert to factory defaults, and the Master Code will reset to its default sequence. Note: Saved user cards and PINs are typically retained during this specific hardware reset. Troubleshooting Guide Issue 1: Keypad keeps beeping and flashing red