Water Softener Installation Manual Free !link!: Harvey Hv3
If the document is not publicly listed, Harvey is legally required to provide product documentation to owners.
Turn the inlet valve slowly to allow water into the tanks. Check for leaks immediately.
Cut into the rising main to fit a bypass valve. This allows you to divert water away from the softener for maintenance or garden use.
A bypass valve network is essential. It allows you to isolate the water softener for maintenance or salt refills while maintaining uninterrupted hard water flow to the rest of the house. The 3-Valve Bypass System The standard setup utilizes three manual ball valves: Directs incoming hard water into the softener. harvey hv3 water softener installation manual free
Before you invest too much time searching the web for a free downloadable PDF, it helps to understand why it might be difficult to find.
Ensure you have easy access to the main cold water pipe and a suitable drain point.
Use PTFE tape on all threaded connections to prevent slow leaks. Step 3: Installing the Drain and Overflow If the document is not publicly listed, Harvey
Before you begin the physical installation, ensure you have the necessary tools and the correct environment for the softener.
The highlights several key features and setup requirements tailored for the non-electric, twin-tank design. Key Installation Features
Add your salt blocks and perform a manual regeneration by turning the white button under the cover one full turn clockwise. Cut into the rising main to fit a bypass valve
Must be installed after the main water shut-off valve but before the plumbing splits into cold and hot water lines.
Ideally installed on a firm, level surface near the main water supply.
Yes, but with caveats. Harvey Water Softeners (a brand owned by the Harvey Group) does not always publicly host every revision of their manuals on their main website. However, you can find legitimate free copies through:
Run a pipe from the overflow fitting on the salt cabinet to an outside location. This ensures that if a fault occurs, the water drains safely outside rather than flooding your home. Step 6: Leak Check Turn on the main water supply slowly. Check for leaks at all connections.
