The system boots normally using the current saved BIOS configurations. This is the default operational state.

Connectors for Solid State Drives (SSDs), Hard Disk Drives (HDDs), and optical drives. 3. Front Panel Header Pinout Configuration

To avoid system instability, always install memory modules that match the board’s exact voltage requirements.

: USB 2.0/3.0, Ethernet (RJ-45), and standard VGA/DVI/HDMI depending on the specific model. General Integration Steps

If your Intel board fails to boot or display a video signal, use the standard Intel diagnostic steps below. Intel Diagnostic Beep Codes : Refresh failure. Reseat the memory.

Action: If your system won’t POST, move the jumper to pins 2-3 for 10 seconds, then back to 1-2.

The large rectangular connector providing power to the chipset, RAM, and expansion slots.

: If the PC boots, open a command prompt and type wmic baseboard get product,manufacturer to output the exact model name. Step 2: Hardware Component Specifications

To get the correct manual, drivers, and support: