Ericsson Mini Link Cli Commands ^new^ -

Ericsson’s Mini‑Link family—compact microwave radio systems used for backhaul and transport—hides a lot of engineering elegance behind a deceptively simple command‑line interface (CLI). For field engineers, integration teams and network troubleshooters, the Mini‑Link CLI is more than a control surface: it’s a precise, scriptable window into device state, configuration and fault data. This essay sketches why the CLI matters, how it’s organized, common workflows and a few practical tips that turn a sequence of commands into reliable, repeatable operations.

Ensure your terminal software (like PuTTY or SecureCRT) is configured to log all session outputs for future auditing.

| Command Output Field | Meaning | Typical Good Value | |----------------------|---------|--------------------| | RSL (Rx Signal Level) | Received signal | -40 to -60 dBm | | XPI (Cross Polarization) | Antenna polarization isolation | >25 dB | | MUT (Minimum Unfaded Threshold) | Fade margin | >30 dB | | TX Power | Transmitted power | +15 to +25 dBm | | BER (Bit Error Rate) | Raw before FEC | < 10^-6 |

ping : Verifies basic network reachability to other sites or management servers.

: Displays board information including Serial number, Type, and Software version. show board [slot] config : Verifies if a board is in service and enabled. show board [slot] status : Checks if a board is in "repair mode". ericsson mini link cli commands

show / get : Displays status, configurations, and operational parameters.

The MINI-LINK CLI operates in a hierarchical structure. You must enter specific modes to modify configurations.

These commands are used for active system management and diagnostic tests.

set radio-link amr-mode — Enables or disables Adaptive Modulation and Coding (AMR). Ethernet and VLAN Configuration Ensure your terminal software (like PuTTY or SecureCRT)

: Switches from standard Exec Mode to Privileged Exec Mode, allowing configuration changes.

Create a text file with CLI commands (one per line) and apply:

To manage a MINI-LINK node through the CLI, you must establish a secure connection to the controller unit. Connection Methods

| Parameter | Meaning | |-----------|---------| | | Received Signal Strength Indicator (dBm) – should be above Rx threshold | | Tx Power | Actual transmit power vs. configured | | Modulation | Current QPSK, 16QAM, 64QAM, 256QAM, 1024QAM | | BER | Bit Error Rate (1e-6 or lower is good) | | MSE | Mean Square Error – quality of demodulation | | ATPC margin | Fade margin remaining when ATPC active | show board [slot] config : Verifies if a

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

show vlan : Displays configured Virtual Local Area Networks (VLANs) and their assigned ports (tagged or untagged).

This guide provides a comprehensive reference for essential Ericsson MINI-LINK CLI commands, covering system navigation, hardware monitoring, radio link configuration, and troubleshooting diagnostics. 1. Accessing and Navigating the MINI-LINK CLI