Sinotimer Mc101 Manual Jun 2026
Use P-2 if you want a light to turn on for 5 seconds when you press a button. Use P-3 if you want a pump to cycle on/off automatically.
Use to select your sensor code (e.g., K for K-type, Pt for PT100). Press SET to confirm. 3. Changing Temperature Units ( C-F ) In the main menu, locate the C-F parameter. Press SET to modify. Select C for Celsius or F for Fahrenheit. Press SET to save. Tuning and Operation Running the Auto-Tune Feature
Access the configuration menu by holding and the LEFT arrow for 3 seconds (Code 11). sinotimer mc101 manual
Are you looking to add (like a PC link or remote alarm)?
: Connect to the designated input terminals (often terminals 4 and 5 or 9 and 10). Use P-2 if you want a light to
Connect the red wire to terminal 10 and blue wire to terminal 9 (verify polarity: +9, -10).
The wiring diagram is typically printed on the side of the controller. Press SET to confirm
: Always disconnect power sources before wiring or servicing.
: Connect the positive wire to Terminal 10. Connect the negative wire to Terminal 9.
Note: Most users simply buy a new MC101 unit, as they are affordable.
Incorrect wiring can permanently damage the controller or your heating elements. Always disconnect the main power supply before wiring. The terminal block is located on the rear of the device and numbers range from 1 to 12. Power Input Line / Live (AC) Terminal 2: Neutral (AC) Sensor Input (Terminals 8, 9, 10) Thermocouples (K-type, J-type, etc.): Connect the Positive (+) wire to Terminal 9 . Connect the Negative (-) wire to Terminal 10 . Terminal 8 remains empty. PT100 RTD (3-Wire):
