The SMA8 is part of the Magnum series and stands out due to its massive scale and dual-chamber design. Unlike mass-produced steel cases, it is constructed entirely from 2.5mm thick aluminum, making it significantly lighter for its size while remaining exceptionally stable.
: Sliding the motherboard tray into its rails and snapping the tool-less exterior panels into place. Verdict : The
While CaseLabs was forced into bankruptcy in 2018, the brand has since been revived and now hosts an official Manuals Archive where you can find assembly instructions and hardware compatibility specs for various models. For the , you should specifically refer to the Magnum Case Owner's Manual
Hand-tighten all structural hardware first before doing a final pass with a screwdriver. Do not over-torque screws into the aluminum threads to avoid stripping. caselabs sma8 manual
Position the (featuring the PCIe slots and rear I/O cutout) against the back edge of the bottom panel and vertical spine.
CaseLabs kits traditionally include bags of mixed hardware. Before turning a single screw, organize your fasteners into distinct groups:
Locate the guide rails on the inside rear of the chassis frame. The SMA8 is part of the Magnum series
: The bottom radiator mount was revised to allow for installation from the outside of the chassis.
If you cannot access a PDF immediately, use this breakdown. The SMA8 is entirely modular. Every single panel is removable.
The SMA8 features a reversible motherboard tray. By default, it is usually set up for Standard ATX on the right side. Verdict : The While CaseLabs was forced into
Secure it to the side pillars using four 6-32 screws per side. Step 3: Attaching the Top Panel and Rear I/O Frame Lower the top chassis panel onto the four vertical pillars. Fasten the top panel loosely to the pillars.
The SMA8 features a completely removable motherboard tray for easy bench-testing. Lay the motherboard tray flat on your table.
Removable tray with integrated PCIe slot structure.
Slide the tray smoothly from the back of the case forward along the tracks.
Before beginning assembly, unbox all components on a soft surface to prevent scratching the powder-coated aluminum. Ensure you have the following structural pieces and hardware: Structural Components