: Select 2A for slow maintenance or 12A for faster charging.
Once the battery reaches a full charge, the lights up green and the charger reduces its output to a safe “float” voltage. This allows you to leave the charger connected for days or weeks without harming the battery. The ammeter will read 0 amps.
Here is the full text of the manual, based on the official user guide provided by Canadian Tire for this product. motomasterbatterycharger111567manual full
A: Correct. The 111567 is strictly for lead-acid, AGM, or Gel. Using it on LiFePO4 will destroy the battery and may cause a fire.
Stand as far back from the physical battery as possible, face away from the unit, and connect the directly to the free end of that 24-inch jumper cable. Phase 3: Powering and Configuring the Unit Motomaster-battery-charger-11-1567-manual - Facebook : Select 2A for slow maintenance or 12A for faster charging
Disconnect all active accessory draws on the battery. Try a higher charge rate, or replace the aging battery. 🧼 Maintenance, Care, and Storage
Before handling any battery or charger, review these critical safety rules to prevent injury or equipment damage. The ammeter will read 0 amps
: Compatible with various 12V lead-acid battery types, including: Conventional/Flooded (Wet) AGM (Absorbed Glass Mat) Deep Cycle Safety Protections Reverse Polarity Protection
: Ensure connections are clean and tight. If the battery voltage is below 1.5V, the charger may not recognize it.
Only operate the charger in outdoor spaces or aggressively ventilated garages. Never seal the charger inside a closed vehicle engine bay or trunk space.