Generally used with Canon PIXMA and some imageCLASS/Maxify models from the G, MG, TS, and iP series. Confirm compatibility for your exact model before use — using the tool on unsupported hardware can cause malfunctions.
Turn off the printer using its physical power button (this saves the new settings to the chip), wait 10 seconds, and turn it back on normally. Troubleshooting Common Errors
– Incorrect use of the service tool (such as resetting the wrong EEPROM values or using an incompatible version) can cause your printer to malfunction permanently. It is always recommended to back up your EEPROM data before performing any operations. canon service tool v5610
Reset the physical waste ink absorber. The software reset only clears the counter. If you ignore the physical waste ink absorber, it can overflow and cause serious damage to your printer. Either replace the ink absorber pad or thoroughly clean and dry the existing one.
– Some users report that the Canon Service Tool V5204 works with certain printer models and can serve as an alternative for resetting the ink absorber counter. Using a service tool that is too old may cause loss of access to Service Mode. Generally used with Canon PIXMA and some imageCLASS/Maxify
Canon printers are engineered with built-in ink absorbers that collect excess ink during printing and printhead cleaning cycles. To prevent ink from leaking out of the machine, the printer uses an internal counter to estimate when these pads are full.
The Canon Service Tool v5610 is an official, proprietary software utility used by Canon technicians to diagnose, test, and reset internal printer parameters. While not officially distributed to the public, various versions have become available online to help users perform advanced maintenance at home. Troubleshooting Common Errors – Incorrect use of the
Resets waste ink absorbers and clears service errors. Operating System: Exclusively designed for Windows. Connection: Works via USB connection ONLY.
Release both buttons simultaneously. The green power LED should flash a few times and then stay solidly lit. Your computer may play a sound indicating new hardware was detected. Step 2: Running the Reset Software
: Configures regional designations and hardware identification markers.
While holding the Stop button, press and . The power LED will light up green.