: Restoring dead or bricked devices through specialized service tools. FRP Bypass : Removing Factory Reset Protection locks.

This driver is not officially hosted on Huawei's main consumer support page, but it is widely available from trusted third-party repair forums and repositories.

Look for a device with a yellow exclamation mark labeled or "Unknown Device" . Right-click the unknown device and choose Update driver . Select Browse my computer for drivers .

To help find the exact firmware files or tools required for your specific recovery process, tell me:

Navigate to the folder where you extracted the driver package, right-click the installer (typically Setup.exe ) and select . Then follow the on-screen prompts to complete the installation.

I can provide the exact test point locations or flashing steps for your specific situation.

Navigate to your extracted folder, open the directory matching your OS architecture (usually x64), select the .inf file (e.g., hw_usb_com.inf ), and click Open.

Devices ranging from older Honor models to legacy Huawei P-series and Mate-series flagships rely on this specific driver configuration for deep system recovery. Step-by-Step Installation Guide

Right-click the file and select to unpack the files onto your desktop. Step 3: Install via Device Manager

Upon reboot, press or F7 to select "Disable driver signature enforcement". Step 2: Extract the ZIP Archive

The "huawei usb com 1.0 driver" is a specialized software package from Huawei that enables a Windows computer to detect and communicate with Huawei smartphones and tablets when they are in a low-level engineering mode often referred to as "COM 1.0 mode" or "USB Serial Port mode". This mode is not the standard MTP or ADB connection you use for everyday tasks like file transfer. Instead, it allows advanced hardware-level access for purposes such as:

What (e.g., Windows 10, Windows 11) are you using?

The is a critical software component required to repair, unbrick, and flash Huawei and Honor smartphones utilizing HiSilicon Kirin processors. When a Huawei device suffers a severe software crash, enters a bootloop, or becomes hard-bricked, it loses its standard Android debugging interface. In this state, the phone can only communicate with a computer through a low-level hardware emergency mode, which the Windows operating system identifies as the "Huawei USB COM 1.0" port.

Click , select the extracted driver folder, and click Next .

Excellent for Kirin-based Huawei devices.