Follow the prompts, accepting the license agreements, and wait for the installation to complete. when prompted.
The adapter is designed for use with Siemens software (STEP 7, TIA Portal, STEP 7‑Micro/WIN). However, third‑party automation software that supports the CP 5711 communication driver may also be compatible. Compatibility depends entirely on whether the third‑party software can interface with the Siemens driver architecture. Some users have reported success with WinSPS from MHJ, but this is not officially supported.
Siemens typically bundles the necessary drivers within their software packages. If you have , the driver is likely already on your system. Simatic Pc Adapter Usb A2 Driver Windows Xp
Select: "Install the software automatically (Recommended)" and click Next .
Before installing the driver, ensure your system meets these requirements: Windows XP Professional SP2 or SP3. Follow the prompts, accepting the license agreements, and
Plug the USB A2 Adapter into a USB port on your PC before starting the installation, or follow the instructions in the readme.txt file, which may advise plugging it in only when prompted.
Set the connection type to or PROFIBUS depending on your PLC. Local Connection: Ensure it is set to USB . Diagnostic: Click "Test" to verify the connection. 5. Troubleshooting Common Issues in Windows XP "Found New Hardware" Loop Siemens typically bundles the necessary drivers within their
After driver installation, you must configure the PG/PC Interface in SIMATIC Manager. Open SIMATIC Manager. Go to > Set PG/PC Interface . In the list, look for PC Adapter.USB.A2.1 .
To ensure a clean installation and avoid driver conflicts on Windows XP, follow this ordered procedure. Step 1: Install the Supporting Siemens Software
: After the reboot, plug the USB A2 Adapter into your PC. The Windows "Found New Hardware Wizard" should appear automatically. Finalize Hardware Wizard "Yes, this time only" for the Windows Update prompt and choose "Install the software automatically"